Design Stamp (punch) is made from heat-treated tool grade steel with a plated coating to prevent from rusting. To work successfully with Design Stamps and punches, place the metal you want to stamp on a hardened steel bench block. The bench block must be on a firm flat surface. Do not use a sand bag or any other padding below. The bench block needs to rest directly on a flat hard surface. Hold the punch perfectly straigh. Use a 16 oz utility hammer to hit the end of the stamp. Ideally the impression should be made with one blow. Practice with copper until you can get a good impression with one blow.
3/8" x 2-1/2"
Face Size: 6mm
Creative Reward Points you'll earn:
Stock Status:(Out of Stock)
Product Code: PUN-603